Home
TechWare Blog
Product Guide
Solutions-Scenario
Resource Center
Turnkey Solution
WISP Business
Basic WISP
Long-Range WISP
Building an ISP
WiFi Mesh-Networking
Niche Market
Project Sites View
Tech-Ware-Store
About Us
Contact Us
Mesh-Smart

[?] Subscribe To
This Site

XML RSS
Add to Google
Add to My Yahoo!
Add to My MSN
Add to Newsgator
Subscribe with Bloglines

TDMoIP Gateway
Solution for wireless E1 transmission

TDMoIPGateway

2-E1/T1;4-E1/T1

2E1/T1
4E1/T1
 
Features
  • Support IEFT RFC4533Structure-Agnostic TDM over Packet (SAToP),
    Metro Ethernet Forum MEF8
  • 4 x E1/T1 NRZ SerialInterface with LOS/AIS detection
  • Use Raw Encapsulationmethod for PDH payload over IP packet
  • Support CircuitEmulation Service over IP
  • Comply with IEFT draftstandard for CESoPSN and SAToP; Metro Ethernet Forum MEF8 IA
  • Support bothPoint-to-Point and Point-to-Multipoint operation
  • Support 4 independentAdaptive Clock recovery block for Ingress PDH (PSN -> TDM) clock
    generation. Recovered clock jitter is compliant to ITU-T G.824/ANSIT1.105 (E1/T1 Jitter Control)
  • Independent configurablejitter buffer depth to compensate up to 250ms of Packet Delay
    Variation
  • Lost packetsprocessing/compensation via PW (Pseudo Wire) control field SequenceNumber
  • Provide Subscriber sideData traffic bandwidth control to guarantee enough TDM payload
    bandwidth
  • PDH LOS detectiontriggered PW L field or payload AIS generation at Egress direction
    (TDM -> PSN)
  • Configurable IEEE 802.3DA/SA assignment
  • Configuration can bemade through RS-232 console port or Easy-to-use GUI
    (Graphic User Interface)
 
Application
Themost cost-effective solution for wireless E1 transmission
 
APSpecification
E1Interfaces
Data Rate 2.048 Mbit/s ±50ppm
LineCode Bipolar with HDB3
TestLoad Impedance 120ohms ±5% resistive, balanced.
LEDindications for E1 ACT,ALM
ConnectorType RJ45
T1Interfaces
DataRate 1.544Mbit/s ±30ppm
LineCode Bipolar with B8ZS
TestLoad Impedance 100ohms ±5% resistive, balanced.
LEDindications for E1 ACT(Active), ALM(Alarm), RDI(Remote Failure)
ConnectorType RJ45
EthernetInterfaces
Compliantwith 802.3 / 802.3u standards
10-BaseTand 100-BaseT with RJ45 connector
Full-duplex
SupportAuto-Negotiation
LEDindications for Ethernet Linkstatus and Act activity
PowerSupply
Power DC -48~ -36 Volt; (Optional) AC 100V ~ 220V, 50 ±5%Hz
PowerConsumption Lessthan 25W
Dimension
Desktop 376W *215D * 44.5H (mm)
OperatingEnvironment
Humidity 5% to95% non-condensing
Temperature 0 to+50 °C
 



footer for TDMoIP Gateway page